FIAT IMMO Bypass
The Immo bypass tool is manufactured to work with Fiat/Lancia/Alfa Romeo vehicles with Immo code system 2. The device can do automatically the following function:
- Identification of the control unit via OBD II.
- Reading the EEPROM of the ECU via OBD II.
- Resetting of the EEPROM to virgin state in the ECU via OBD II.
- Emulation of the Immo system code.
All these functions will allow you to start the vehicle while the device is plugged into the OBD II connector of the car and drive it to your service where you can program new transponder key. When you remove the device from the OBD II connector the car will not start anymore until you plug in the device again into the OBD II connector while the ECU will stay in virgin mode and you will be able to adapt any BSI or Immo box with existing working key! The whole procedure is done for 10-20 seconds.
The device works on the following Engine ECU’s made by Magneti Marelli which can communicate !!! ONLY !!! under CAN BUS diagnostic protocol:
5SF8 - petrol ECU - 1.2/1.4 liter
5SF9 - petrol ECU - 1.2/1.4 liter
8FMW - petrol ECU - 1.4 liter
8GSW - petrol ECU - 1.4 liter
8GSF - petrol ECU - 1.4 liter
9GF - new petrol ECU - 1.2 liter (2014-2015)
6F3 - diesel ECU - 1.3 liter
8F2 - diesel ECU - 1.3 liter (2.3 for DUCATO only)
8F3 - diesel ECU - 1.3 liter (2.3 for DUCATO only)
These Engine ECU’s types are built into the following vehicles models:
FIAT 500 – 2007 - 2015
FIAT 500l – 2007 - 2015
FIAT Punto/Grande Punto – 2007 - 2015
FORD Ka – 2007 - 2015
New Lancia Ypsilon – 2012 - 2015
New FIAT Panda – 2012 - 2015
FIAT Ducato - 2010 - 2014 (only with Magneti Marelli ECU 8F2 and 8F3)
Alfa Romeo MITO - 2008 - 2015 (1.4 petrol and 1.3 diesel)